Its super easy and cheap… thats if you have clear tape in your house; not the small scotch tape
but the large box sealing tapes. Make sure before you start that the screen is clean of oil or small
particles of anything.

You will need a roll of clear tape, razor, razr =D or anything with a screen that you want to
protect, water (which is in star wars cup), and dish cleaning soap.
Step One

Add two or three drops of soap into the cup of water and mix.
Step Two

Put a dab or two of the soap/water solution onto the screen, then spread it around the screen.
Try your best to get rid of the white bubbles. Do not wipe the soap/water solution off.
The solution makes it easier to get rid of the air bubbles under the tape.
Step Three

Put a strip of tape on the screen and then press against the screen like crazy>=] to get rid
of the air bubbles. Make sure the tape touches the outside part of the screen (in this picture, the silver
part of the razr) so it wont move when you cut the the tape.
Step Four

Cut the outline of the screen. Some devices has small gaps between the screen and the body so
it will guide your razor. If it does not have a gap then use a ruler to guide the razor.
Make sure your cutting it slowly and lightly. When your done then pull off the outside scraps slowly..
Step Five

Let it dry for an hour or two =D and then your done.. =D